Ford Mustang (1999-2004) Service Manual: Knob
Removal
1. Remove the shifter top control panel.
2. Disconnect the electrical connectors.
3. Remove the shifter bezel.
4. Remove the bulb from the bezel.
5. Disconnect the TCS connector.
6. CAUTION: Extra force may be needed to lift up on the handle. Do not to pull too far or damage to the overdrive cancel button may result, as the wires may be pulled out of the switch.
Remove the screw and the handle.
7. Remove the transmission control switch.
Installation
1. To install, reverse the removal procedure.
Bulb
Removal and Installation 1. Remove the floor console. For additional information, refer to Section. 2. Remove the bolts, then position the bezel upward. 3. Remove the bulb socket from the bez ...Other materials:
A/C Compressor Pressure Relief Valve
An A/C compressor pressure relief valve is incorporated into the compressor
A/C manifold and tube to:
relieve unusually high refrigerant system discharge pressure buildups.
For specifications
regarding operating pressure(s), refer to Section.
prevent ...
Transmission (Assembly)
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
Holding Fixture, Transmission
307-003 (T57L-500-B)
Remover/Installer, Bearing
Tube
308-024 (T75L-7025-B)
Re ...
Shift Patterns
Upshifts
Transmission upshifting is controlled by the powertrain control
module (PCM). The PCM receives
inputs from various engine or vehicle sensors and driver demands to
control shift scheduling, shift feel
and torque converter clutch (TCC) opera ...