Ford Mustang (1999-2004) Service Manual: Lamp Assembly - Map/Dome
Removal
1. Disconnect the battery ground cable.
2. Remove the lamp lens from the lamp assembly.
3. Remove the lamp assembly.
1. Remove the screws.
2. Remove the lamp assembly.
- Disconnect the electrical connectors.
Installation
1. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
To install, reverse the removal procedure.
Pinpoint Tests
CAUTION: Before removing and installing the GEM or its connectors, disconnect the battery. Failure to follow this caution will result in the GEM storing many erroneous DTCs and may result in the ...Daytime Running Lamps
Torque Specifications Daytime Running Lamps (DRL) The daytime running lamp (DRL) system consists of a daytime running lamp module and bracket assembly (15A270). The module is located on the front ...Other materials:
Column
Removal and Installation
All vehicles
1. Disconnect the battery ground cable and wait at least one minute to allow
the depletion of the
restraint system backup power supply.
2. WARNING: To avoid the risk of serious personal injury, follow all
warnings,
c ...
Removal
1. Remove the center instrument panel register.
2. Remove the screws.
3. Disconnect the connectors.
4. Using the special tool, disconnect the temperature control cable from the
control head.
5. Remove the nuts and disconnect the vacuum connector.
...
Transmission (Installation)
Material
Item
Specification
DEXRON III (ATF)
Transmission Fluid
XT-2-QDX or equivalent
DEXRON III
Pipe Sealant with Teflon
D8AZ-19554-A or equivalent
WSK-M2G350-
A2
Premium Long Life Grease
XG-1-C, K or T or equivalent
...