Ford Mustang (1999-2004) Service Manual: Lamp Assembly - Rear
Removal
1. Position the luggage compartment trim aside.
- Remove the two retainers.
2. Remove the four rear lamp nuts.
3. Remove the rear lamp assembly, disconnect the electrical connectors and replace the bulbs if necessary.
Installation
1. To install, reverse the removal procedure.
Lamp Assembly - Fog Lamp (GT)
Removal 1. Raise and support the vehicle. 2. Remove the screw. 3. Partially lower the vehicle and remove the fog lamp assembly. 1. Disconnect the electrical connector. 2. Remove the two sc ...Lamp Switch - Headlamp
Removal 1. Disconnect the battery ground cable. 2. Remove the headlamp switch knob. 1. Pull the headlamp switch knob out. 2. Insert a thin tool into the slot, pull and remove the headlamp sw ...Other materials:
Handle - Interior Door
Removal
1. Remove the door trim panel (23942). For additional information,
refer to Section.
2. Remove the rivet.
3. Remove the cable clip.
4. Release the cable housing from the interior handle.
5. Release the actuating cable from the interior ha ...
Accelerator Pedal and Shaft
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the accelerator pedal and shaft.
Remove the nuts.
Remove the accelerator pedal and shaft.
3. To install, reverse the removal pro ...
Keyless Entry/Computer Operated Locks
Programming -Keyless Entry Remote Transmitter
NOTE: All keyless entry remote transmitters (15K601) must be
programmed at the same time.
NOTE: All previous transmitter identification codes (TIC's) will be
erased when programming mode is
entered.
...