Ford Mustang (1999-2004) Service Manual: Latch - Door
Removal
1. Remove the door trim panel (23942). For additional information, refer to Section.
2. Release the actuating rods by opening the clips.
3. Using a screwdriver, release the lock cylinder actuating rod.
4. Remove the door latch screws.
5. Disconnect the door ajar switch and the actuator electrical connectors.
6. Remove the water shield.
7. Release the interior door handle actuating cable.
8. Remove the door latch.
Installation
1. To install, reverse the removal procedure.
Handles, Locks, Latches And Mechanisms (Description and Operation)
Lock Cylinders Individual lock cylinders are repaired by discarding the inoperative lock cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair ...Latch - Luggage Compartment Lid
Removal 1. NOTE: The luggage compartment lid latch is equipped with mechanical interior release handle. Disconnect the luggage compartment lid lock actuator (432A38) cable. 2. Remove the lug ...Other materials:
Valve - Springs, Retainer and Valve Stem Seal
Special Tool(s)
Compressor, Valve Spring
303-452 (T93P-6565-AR)
Installer, Valve Stem Oil Seal
303-383 (T91P-6571-A)
Compressor, Valve Spring
303-567 (T97P-6565-AH)
Spacer, Valve Spring
Compressor
303 ...
Engine Dynamic Balance Shaft
Removal
1. Remove the timing chain (6268). For additional information, refer to
Timing Chain in this
section.
2. Disconnect and position the wire harness aside.
3. Remove the radiator fan and shroud assembly (8146).
4. Remove the engine dynamic balan ...
Installation
1. Inspect the rear axle pinion flange seal journal for rust, nicks, and
scratches prior to installing
the flange. Polish the seal journal with fine crocus cloth, if necessary.
2. Lubricate the rear axle pinion flange splines.
Use SAE 75W-140 High Performa ...