Ford Mustang (1999-2004) Service Manual: Link - Stabilizer Bar

Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to ensure correct retention of these parts.

1. Raise the vehicle on a hoist.

2. Disconnect the front stabilizer bar links (5K483) from the front stabilizer bar (5482).

1. Remove the nuts and bushings. Discard the nuts.

2. Rotate the stabilizer bar to disconnect the links.

Link - Stabilizer Bar

3. Remove the stabilizer bar links.

1. Remove the nuts and bushings.

2. Remove the stabilizer bar links.

Link - Stabilizer Bar

Installation

1. To install, reverse the removal procedure.

Link - Stabilizer Bar

 

Link - Stabilizer Bar

    Bar - Stabilizer
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...

    Bushing - Stabilizer Bar
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...

    Other materials:

    Front Subframe - 3.8L Engine
    Special Tool(s) 3-Bar Engine Support Kit 303-F072 Lifting Bracket Set, Engine 303-D095 (D94L-6001-A) (014- 00792) Removal and Installation All vehicles 1. Remove the steering gear. For additional information, refer to Section. ...

    Gearshift Rail and Fork
    Disassembly and Assembly 1. Using a 5/32-inch drift and a hammer, remove and discard the split pin. Slide the shift fork from the shift rail. 2. Remove the gearshift fork inserts. 3. CAUTION: Support the shift rail to prevent damage to the parts. Positio ...

    Pinpoint Test J: LFC 34/DTC B1934 - Driver Air Bag Circuit Resistance Low
    Normal Operation The restraints control module (RCM) monitors the resistance of the driver air bag ignitor by measuring the resistance between pins 3 and 4. If the RCM detects low resistance between these pins, it will store a diagnostic trouble code (D ...