Ford Mustang (1999-2004) Service Manual: Lower Arm

Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Mark the rear shock absorber (18125) relative to the protective sleeve with the vehicle in a static, level ground position (curb height).

Lower Arm

2. Remove the muffler assembly(ies).

3. Remove the rear spring (5560). For additional information, refer to Spring-Coil in this section.

4. Remove the lower suspension arm and bushing (5A649) from the body attachment.

1. Remove and discard the bolt and nut.

2. Remove the lower arm.

Lower Arm

Installation

1. Install the lower suspension arm and bushing to the body attachment.

1. Position the lower arm.

2. Install a new bolt and a new nut. Do not tighten at this time.

Lower Arm

2. NOTE: Tighten the lower suspension arm and bushing-to-body attachment bolt after installing the spring while the suspension is at curb height.

Install the rear spring. For additional information, refer to Spring-Coil in this section.

Lower Arm

3. Install the muffler assembly(ies).

    Installation
    CAUTION: The upper suspension arm and bushing nuts must be tightened with the suspension at curb height. Failure to do so can result in bushing failure, resulting in poor ride and handling. NOTE: If ...

    Stabilizer Bar
    Removal CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the sa ...

    Other materials:

    Cooler - Fluid
    Removal 1. Raise and support the vehicle. 2. Disconnect the power steering hoses. 3. Remove the bolt and routing bracket. 4. Remove the bolts and the power steering fluid cooler. Installation 1. To install, reverse the removal procedure. 2. Fill and ...

    Summer tires (if equipped)
    Summer tires provide superior performance on wet and dry roads. Summer tires do not have the Mud and Snow (M+S or M/S) tire traction rating on the tire side wall. Since summer tires do not have the same traction performance as All-season or Snow tires, Ford do ...

    Evaporative Emission Test Port
    Removal and Installation 1. Disconnect the pin-type retainer. 2. Raise and support the vehicle. For additional information, refer to Section. 3. Remove the RH front wheel. For additional information, refer to Section. 4. Remove the RH front splash shiel ...