Ford Mustang (1999-2004) Service Manual: Lower Intake Manifold
Material
Installation
1. Install a new upper intake manifold gasket. 2. NOTE: Refer to the location note made during removal and make sure the bolts are installed in the correct locations. Install the upper intake mani ...Removal
1. Remove the upper intake manifold. For additional information, refer to Upper Intake Manifold in this section. 2. Partially drain the cooling system. For additional information, refer to Sect ...Other materials:
Driving through water
WARNING: Drive through water in an emergency only, and not
as part of normal driving.
WARNING: Engine damage can occur if water enters the air
filter.
Note: Driving through deep water may allow water into the transmission
or air intake and can cause internal v ...
Valve Cover RH
Removal and Installation
1. Remove the throttle body. For additional information, refer to
Section.
2. Disconnect the crankcase vent hose.
3. Remove the differential feedback exhaust gas recirculation (EGR) system
vacuum hoses and
the bracket bolts. Po ...
Vacuum Control Motor - Air Inlet Duct Door
Removal
1. Remove the instrument panel.
2. Disconnect the vacuum hose.
3. Disconnect the control arm.
4. Remove the vacuum control motor.
Remove the screws.
Installation
1. To install, reverse the removal procedure. ...