Ford Mustang (1999-2004) Service Manual: Lumbar Assembly
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front Power in this section.
2. Release the J-clip.
3. Remove the seat backrest latch handle knob (62762).
4. Pull the seat backrest trim cover up to the top of the seat.
5. Remove the seat backrest foam pad from the seat backrest frame.
Vehicles with standard power lumbar
6. Disconnect the power lumbar support air hose.
7. Remove the seat backrest adjuster (65500).
Vehicles with power bolster and lumbar
8. Disconnect the lumbar and bolster air supply hoses.
9. Remove the two screws and remove the lumbar and bolster adjuster pad.
All vehicles
10. To install, reverse the removal procedure.
Front Seat Backrest
Removal and Installation All vehicles 1. Remove the seat. For additional information, refer to Seat-Front Power in this section. 2. Remove the front seat backrest latch. For additional informati ...Seat - Front Power
Removal and Installation 1. Remove the safety belt through the opening in the safety belt guide. 2. Move the seat forward. 3. Remove the bolt covers and remove the seat track bolts. 4. Move the ...Other materials:
Removal
WARNING: The restraints control module (RCM) orientation is critical
for proper system
operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) has been
involved in a collision in which the center tunnel area has been damaged,
in ...
Reverse Clutch
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C)
Compressor, Clutch Spring
307-015 (T65L-77515-A)
Protector, Transmission
Reverse Clutch Outer Fluid
Seal
307-424
Protecto ...
Air Conditioning (A/C) Compressor - 4.6L
Material
Item
Specification
PAG Refrigerant Compressor
Oil (R-134a Systems)
F7AZ-19589-DA (Motorcraft YN-
12-C)
WSH-M1C231-
B
Removal and Installation
CAUTION: If installing a new air conditioning compressor due to an
internal failur ...