Ford Mustang (1999-2004) Service Manual: Mass Air Flow (MAF) Sensor - 3.8L

Removal

CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element (internal to housing) or possible failure to the mass air flow sensor may occur.

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Remove the air cleaner and duct assembly. For additional information, refer to Section.

3. Release the four tabs and remove the mass air flow (MAF) sensor.

Mass Air Flow (MAF) Sensor -3.8L

4. Disconnect the connector.

Mass Air Flow (MAF) Sensor -3.8L

5. Remove the mass air flow sensor (MAF).

  • Remove the nuts and the MAF sensor.

Mass Air Flow (MAF) Sensor -3.8L

Installation

1. To install, reverse the removal procedure.

    Engine Coolant Temperature (ECT) Sensor - Mach I
    Material Item Specification Pipe Sealant with Teflon D8AZ-19554-A WSK-M2G350-A2 Removal and Installation 1. Remove the air intake scoop. For additional information, refer to S ...

    Mass Air Flow (MAF) Sensor - 4.6L (2V)
    Removal CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element ...

    Other materials:

    Paint Codes
    The first set of paint code letters/numbers listed indicate the vehicle primary body color. The second set of paint code letters/numbers listed (if applicable) indicate a two-tone or accent body color. B7 - Zinc Yellow (clear coat) CX - Dark Shadow Gray ...

    Key Programming - Additional Key With One Programmed Key
    Special Tool(s) Worldwide Diagnostic System (WDS) 418-F224, New Generation STAR (NGS) Tester 418-F052, or equivalent diagnostic tool NOTE: This procedure is used when a customer needs to have an additional key programmed into the veh ...

    Caliper
    1. NOTE: It is not necessary to do a complete brake system bleed if only the disc brake caliper (2B120) was disconnected. Place a box end wrench on the disc brake caliper bleeder screw (2208). Attach a rubber drain tube to the disc brake caliper b ...