Ford Mustang (1999-2004) Service Manual: Mass Air Flow (MAF) Sensor - 4.6L (2V)
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element (internal to housing) or possible failure to the mass air flow sensor may occur
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the air cleaner outlet tube. For additional information, refer to Section.
3. Remove the mass air flow sensor (MAF).
- Disconnect the connector.
- Remove the four nuts and the MAF sensor.
Installation
1. To install, reverse the removal procedure.
Mass Air Flow (MAF) Sensor - 3.8L
Removal CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element ...Mass Air Flow (MAF) Sensor - Cobra
Removal and Installation 1. Disconnect the intake air temperature (IAT) sensor. 2. Disconnect the breather hose. 3. Disconnect the vacuum hose. 4. Loosen the clamps and remove the air cleaner ...Other materials:
Sensor Indicator - Rear
Special Tool(s)
Pinion Bearing Cone Remover
205-D002 (D79P-4621A)
Axle Bearing/Seal Plate
205-090 (T75L-1165-B)
Sensing Ring Replacer
206-041 (T89P-20202-A)
Removal
1. Remove the rear axle shaft bearing.
2. Using the special ...
Air Bag Supplemental Restraint System (SRS) (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 46 , Air Bag for schematic and connector
information.
Special Tool(s)
Diagnostic Tool, Restraint
System
418-F088 (105-R0012)
Restraint System Diagnostic Tool Warning
WARNING: This tool is for restraint system se ...
Installation
1. CAUTION: Timing chain procedures must be followed exactly or damage
to the
pistons or valves will result.
Compress the tensioner plunger, using a soft-jawed vise.
2. Install a retaining clip on the tensioner to hold the plunger in during
installation.
...