Ford Mustang (1999-2004) Service Manual: Mass Air Flow (MAF) Sensor - Mach I
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing element (internal to housing) or possible failure to the mass air flow sensor may occur
1. Disconnect the battery ground cable. For additional information, refer to Section.
2. Remove the air cleaner outlet tube. For additional information, refer to Section.
3. Remove the mass air flow sensor (MAF).
- Disconnect the connector.
- Remove the four nuts and the MAF sensor.
Installation
1. To install, reverse the removal procedure.
Mass Air Flow (MAF) Sensor - Cobra
Removal and Installation 1. Disconnect the intake air temperature (IAT) sensor. 2. Disconnect the breather hose. 3. Disconnect the vacuum hose. 4. Loosen the clamps and remove the air cleaner ...Heated Oxygen Sensor (HO2S)
Special Tool(s) Socket, Exhaust Gas Oxygen Sensor 303-476 (T94P-9472-A) Material Item Specification Penetrating and Lock Lubricant or equivalent E8AZ-19A501- B ...Other materials:
Battery (Removal and Installation)
Removal and Installation
WARNING: Batteries normally produce explosive gases which can
cause personal injury.
Therefore, do not allow flames, sparks or lighted substances to come
near the battery. When
charging or working near a battery, always sh ...
Mass Air Flow (MAF) Sensor - Cobra
Removal and Installation
1. Disconnect the intake air temperature (IAT) sensor.
2. Disconnect the breather hose.
3. Disconnect the vacuum hose.
4. Loosen the clamps and remove the air cleaner outlet pipe.
5. CAUTION: The mass air flow (MAF) sensor ho ...
Heater Core Backflushing
Special Tool(s)
Flush Kit
164-R3658 or equivalent
Drain Kit
164-R3662 or equivalent
Material
Item
Specification
Motorcraft Premium Cooling
System Flush
VC-1 or equivalent
ESR-M14P7-A
Motorcraft Premium ...