Ford Mustang (1999-2004) Service Manual: Master Cylinder
Removal
1. Disconnect the fluid level sensor connector.
2. Disconnect the brake tubes.
3. Remove the brake master cylinder nuts.
4. Remove the brake master cylinder (2140).
Installation
1. To install, reverse the removal procedure.
- Bleed the brake system.
Pedal and Bracket
Removal 1. Disconnect the battery ground cable (14301). 2. Remove the stoplight switch retaining pin. 3. Slide the stoplight switch (13480) and booster push rod from the brake pedal pin. 4. Re ...Master Cylinder - Hydro-Boost
Removal 1. Disconnect the fluid level sensor connector. 2. Disconnect the brake tubes. 3. Remove the brake master cylinder nuts. 4. Remove the brake master cylinder (2140). Installation 1. T ...Other materials:
Adjusting the headlamps
The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident, an authorized dealer should
check the alignment of your headlamps.
Vertical Aim Adjustment
1. Park the vehicle directly in front of a wall or scre ...
Manual Control Lever Shaft and Seal
Special Tool(s)
Installer, Shift Shaft Fluid Seal
307-050 (T74P-77498-A)
Alignment Gauge, TR Sensor
307-351 (T97L-70010-A)
Removal
1. Drain the transmission fluid and remove the fluid pan and filter. For
additional information, ...
Crankshaft Position (CKP) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Remove the crankshaft position (CKP) sensor.
Disconnect the connector.
Remove the bolts and the sensor.
Installation
1. To install, reverse ...