Ford Mustang (1999-2004) Service Manual: Mirror - Motor
Removal
1. Push in the upper edge of the mirror glass to the maximum travel.
2. Grasp the bottom of the mirror glass, pull outward and remove the mirror glass.
3. Remove the mirror motor screws.
4. Disconnect the mirror motor electrical connector.
5. Remove the mirror motor.
Installation
1. NOTE: When installing the mirror glass, make sure it snaps completely into the mirror motor.
To install, reverse the removal procedure.
Rear View Mirrors (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 124 , Power Mirrors for schematic and connector information. Special Tool(s) 73III Automotive Meter 105-R0057 or equivalent Flex Probe Kit ...Switch - Exterior Rear View Mirror Control
Removal 1. CAUTION: Use a shop towel or similar material between the tool and the front door trim panel or damage to the front door trim panel may occur. Position the window regulator switch plat ...Other materials:
Actuator - Speed Control Servo
1. CAUTION: Electronic modules are sensitive to static electrical
charges. If exposed
to these charges, damage may result.
Disconnect the battery ground cable.
2. Remove the LH wheel and tire; refer to Section.
3. Position aside the LH front splash shie ...
Hydraulic Control Unit
Removal
1. Disconnect the battery ground cable(14301).
2. Disconnect the anti-lock-brake control module electrical connector.
3. NOTE: The 4 wheel anti-lock brake system (4WABS) with traction
control is shown , the
4WABS without traction control system is ...
Inspection and Verification
1. The interior lighting system is a generic electronic module (GEM)
controlled system.
2. Verify the customer concern by operating the interior lighting system.
3. Visually inspect for the following obvious signs of mechanical and
electrical damage.
...