Ford Mustang (1999-2004) Service Manual: Moulding - Rocker Panel
Removal
1. Remove the front rocker panel moulding screw.
2. Remove the strip.
3. Remove the rear rocker panel moulding screw.
4. Remove the pin-type retainers and the rocker panel moulding.
Installation
1. To install, reverse the removal procedure.
Moulding - Roof Side
Removal and Installation 1. Remove the weatherstrip. 2. Remove the exterior roof side moulding screws. 3. Remove the interior roof side moulding screws. 4. Remove the roof side moulding screw. ...Rear Spoiler
Removal and Installation 1. Open the luggage compartment lid. 2. Disconnect the high mounted stoplamp electrical connector. 3. Remove the screws and the nuts. 4. CAUTION: Use care not damge t ...Other materials:
Air Bag Disposal - Driver, Undeployed, Scrapped
Vehicle
Remote Deployment
WARNING: Always wear safety glasses when repairing an air bag
supplemental restraint
system (SRS) vehicle and when handling an air bag module or safety belt
retractor/pretensioner assembly. This will reduce the risk of injury in
t ...
Sensor - Front
Removal
1. Remove the wheel and tire assembly.
2. Remove the inner fender splash shield.
1. Remove the inner fender splash shield push pins.
2. Remove the inner fender splash shield screw.
3. Remove the inner fender splash shield.
3. Remove the front ...
Installation
1. Inspect the rear axle pinion flange seal journal for rust, nicks, and
scratches prior to installing
the flange. Polish the seal journal with fine crocus cloth, if necessary.
2. Lubricate the rear axle pinion flange splines.
Use SAE 75W-140 High Performa ...