Ford Mustang (1999-2004) Service Manual: Multifunction Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and turn to RUN position.
2. Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. Remove the tilt wheel handle.
4. Remove the upper and lower steering column shrouds.
1. Remove the screws.
2. Remove the upper and lower steering column shrouds.
5. Remove the multifunction switch.
1. Remove the screws.
2. Disconnect the electrical connectors.
3. Remove the multifunction switch.
Installation
1. NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
To install, reverse the removal procedure.
Steering Column Switches (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 13 , Power Distribution for schematic and connector information. Refer to Wiring Diagrams Cell 81 , Interval Wiper/Washer for schematic and connector information. Refer ...Ignition Switch
Removal 1. Disconnect the battery ground cable. 2. Remove the lower instrument panel steering column cover. 1. Remove the screws. 2. Remove the lower instrument panel steering column cover. ...Other materials:
Communications Network (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 14 , Multiplex Communication Network for
schematic and connector
information.
Special Tool(s)
73 Digital Multimeter or
equivalent
105-R0051
Worldwide Diagnostic System
(WDS)
418-F224,
New Genera ...
Symptom Chart
Condition
Possible Sources
Action
Incorrect/erratic direction
of airflow from outlet(s)
No vacuum to A/C heater
function switch selector.
A/C heater function selector
switch leaks vacuum.
Kinked/pinched vacuu ...
Installation
1. Install the bearing, snap ring, hub and dust shield. For additional
information, refer to Wheel
Hub-Cobra in this section.
2. Install the knuckle.
1. Position the knuckle on the lower suspension arm and bushing.
2. Install a new bolt and a new nut. Do ...