Ford Mustang (1999-2004) Service Manual: Oil Level Indicator and Tube
Removal
1. Remove the oil level indicator.
2. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold LH in this section.
3. Remove the bolt.
4. Remove the oil level indicator tube.
Installation
1. To install, reverse the removal procedure.
Oil Filter Adapter
Removal 1. Drain the cooling system. For additional information, refer to Section. 2. Disconnect the lower radiator hose. 3. Raise the vehicle. For additional information, refer to Section. 4. Dra ...Oil Pan
Special Tool(s) Compressor, Coil Spring 204-D001 (D78P-5310-A) Lifting Bracket, Engine 303-D088 (D93P-6001-A2) 3-Bar Engine Support Kit 303-F072 Materia ...Other materials:
Removal
1. Use a suitable suction device to lower the brake fluid level in
the master cylinder reservoir.
2. Raise and support the vehicle.
3. Remove the wheel and tire assembly.
4. Inspect the pads for wear or contamination, install new if worn to ...
Symptom Chart
Condition
Possible Sources
Action
The Brakes Pull or
Drift
Tire air pressure.
Wheel alignment.
Brake pads.
Brake components.
Suspension
component.
Go To Pinpoint Test A .
...
Fittings - R-Clip
Material
Item
Specification
SAE 5W-20 Super Premium
Synthetic Blend Motor Oil
XO-5W20-QSP or equivalent
WSS-M2C153-
H
Disconnect
WARNING: Do not smoke or carry lighted tobacco or open flame of any
type when
working on or near any fuel- ...