Ford Mustang (2005-2014) Owners Manual: Opening the convertible top

Note: Do not store articles behind rear seat. Articles stored in the convertible top stowage compartment may break the rear glass window when the top is opened.

Note: Opening the convertible top when the top material is wet may cause mold or mildew.

The convertible top can be opened with the side windows down. The windows will automatically lower when opening or closing the top.

The convertible top will not operate unless the vehicle is stationary or traveling under 3 mph (5 km/h).

To open the convertible top:

1. Bring the vehicle to a complete stop. The ignition must be on. It is recommended that the engine is running when opening the top to prevent draining the battery.
2. Check the convertible top stowage compartment behind the rear seat to be sure it is empty. Make sure the convertible top outer surface is free of debris.

Note: The latch handles must be pulled downward fully to allow the latch to fully rotate into the open position.

3. Unclamp the top from the windshield header by pulling each latch handle down and then rotating the latch to the rear until it clears the header.

Note: If the top has not been opened for some time and sticks to the windshield header, push the front of the top up slightly with your hand to loosen it.

4. Press and hold the convertible top switch on the overhead console until the windows are completely down and the top is completely stored.

    Using the boot
    Installing the Boot WARNING: Always secure the retaining clips and boot straps on the vehicle or the boot may come loose while driving. Note: Be sure the boot is secure on the vehicle before driving. ...

    Other materials:

    Removal
    1. Disconnect the battery negative cable. 2. Drain the engine cooling system. 3. Remove the RH exhaust manifold. For additional information, refer to Exhaust Manifold RH in this section. 4. Remove the lower intake manifold. For additional information, re ...

    Removal
    NOTE: This procedure applies to both the LH and RH halfshafts. 1. CAUTION: The vehicle must be on level ground and at curb height. Mark the rear shock absorber relative to the protective sleeve. During installation, raise the suspension to this reference ...

    Engine (Disassembly)
    Special Tool(s) Impact Slide Hammer 100-001 (T50T-100-A) Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D) Holding Tool, Crankshaft 303-448 (T93P-6303-A) Guides, Connecting Rod 303-442 (T93P- ...