Ford Mustang Service Manual: Output Shaft

Manual Transmission

The T56 six-speed manual transmission features the following:

  • six forward speeds and one reverse speed.
  • forward gears are synchronized and helical cut.
  • a reverse gear operates through a constant-mesh, fully synchronized system.
  • a shift interlock system prevents the engagement of more than one gear.
  • a countershaft with two sections, the countershaft cluster and the countershaft extension. The countershaft cluster is serviced as an assembly, the countershaft extension components are serviced.
  • two tapered roller bearings on the output shaft.
  • two tapered roller bearings on the countershaft cluster.
  • a tapered roller bearing on the input shaft.
  • a tapered roller bearing on the countershaft extension.
  • countershaft cluster endplay controlled by shims located in the transmission adapter plate.
  • countershaft extension endplay controlled by shims located in the extension housing.
  • input/output shaft endplay is controlled by shims located in the transmission adapter plate.
  • removable wear pads on the shift forks.
  • an aluminum main case, extension housing, adapter plate and clutch housing.

Transmission Identification

The transmission identification tag is located under the lower bolt that retains the extension housing to the main case.

The six speed (T56) transmission is available for the Mustang 4.6L (4V).

Transmission Identification

 


 


Transmission Draining and Filling


Input Shaft and Bearing
Manual Transmission The T56 six-speed manual transmission features the following: six forward speeds and one reverse speed. forward gears are synchronized and helical cut. a reverse gear operates ...

Disassembly
Disassembly   1. CAUTION: Hand tighten the special tool to prevent gear damage. CAUTION: Support the output shaft while using the press to prevent damage to the shaft or gears. Using the spec ...

Other materials:

Camber Adjustment - Rear
Wheel Alignment Angles Camber and toe are adjustable on the front suspension systems. Front camber is adjusted by moving the top of the strut and spring assembly. Rear camber is adjusted by means of eccentric cams on the rear upper arms. Caster is preset at ...

Transmission Control Switch
External Controls (Description and Operation) The transmission shift cable transfers the transmission operating mode from the gearshift lever to the automatic transmission (7003). The indicated position of the transmission floor mounted selector lever is tra ...

Keyless Entry/Computer Operated Locks
Programming -Keyless Entry Remote Transmitter NOTE: All keyless entry remote transmitters (15K601) must be programmed at the same time. NOTE: All previous transmitter identification codes (TIC's) will be erased when programming mode is entered. ...