Ford Mustang (1999-2004) Service Manual: Output Shaft and Direct Clutch Cylinder
Special Tool(s)
Compressor, Clutch Spring 307-015 (T65L-77515-A) | |
Protector, Piston Seal 307-080 (T80L-77234-A) | |
Protector, Transmission Direct Clutch Outer Fluid Seal 307-422 |
Material
Item | Specification |
MERCON V Automatic Transmission Fluid XT-5-QM, XT-5-DM | MERCON V |
Output Shaft, Direct Clutch Cylinder and Ring Gear Disassembled View
Direct Clutch Disassembled View
Reverse Sun Gear
Disassembly 1. Remove the reverse clutch sun gear assembly and the No. 4 forward clutch hub bearing and race. 2. Remove the forward clutch sun gear assembly and the No. 5 forward clutch ...Disassembly
1. NOTE: The index mark on the output shaft must be aligned with the index mark on the output shaft ring gear during the assembly procedure. Remove the ring gear snap ring. 2. Separate the ring gea ...Other materials:
Toe Adjustment - Front
1. Start the engine and center the steering wheel.
2. Turn the engine off, and hold the steering wheel in the straight forward
position by attaching a
rigid link from the steering wheel to the seat.
3. Check the toe settings. Follow the manufacturer's instr ...
Key Programming - Erase All Key Codes and Program Two
Keys
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052 or equivalent
diagnostic tool
NOTE: This procedure is used when a customer needs keys programmed
into the system and does
not have ...
Pinpoint Tests
CAUTION: Before removing and installing the GEM or its connectors,
disconnect the
battery. Failure to follow this caution will result in the GEM storing many
erroneous DTCs and it
may exhibit erratic operation after installation.
CAUTION: Be careful when pr ...