Ford Mustang (1999-2004) Service Manual: Output Shaft Speed (OSS) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. Disconnect the electrical connector.
3. Remove the output shaft speed (OSS) sensor.
4. To install, reverse the removal procedure.
Transmission (Removal)
1. Disconnect the battery ground cable. For additional information, refer to Section. 2. Remove the gearshift lever knob. 3. Remove the console panel gearshift plate. Lift the gearshift lever boot ...Other materials:
Lumbar Control Switch
Removal and Installation
All vehicles
1. Remove the front seat. For additional information, refer to Seat-Front
Power in this section.
Vehicles with standard power lumbar
2. Pull to remove the lumbar control switch (14C715).
3. Disconnect the power lum ...
Rear View Mirrors
Torque Specifications
Rear View Mirrors
The rear view mirror system consists of the following components:
exterior rear view mirror
exterior rear view mirror control
exterior rear view mirror glass
exterior rear view mirror motor
interior ...
Disc
Removal
1. Remove the front disc brake caliper anchor plate (2B292). For
additional information, refer to
Brake Caliper Anchor Plate in this section.
2. Match mark the hub (1104) and the brake disc (1125).
3. If necessary, remove and discard the kee ...