Ford Mustang (1999-2004) Service Manual: Overdrive Servo
Special Tool(s)
Remover/Installer, Servo Piston 307-251 (T92P-70023-A) |
Removal
1. Remove the main control valve body. For additional information, refer to Main Control Valve Body in this section.
2. NOTE: If the tool is not available, extreme care must be taken. Spring pressure will force overdrive servo piston assembly out of case. Case bore damage may result from trying to pry on overdrive servo internal retaining ring.
Using the special tool, compress the servo spring to remove the overdrive servo retaining ring.
3. Remove the overdrive servo piston and return spring.
Installation
1. Install the overdrive servo piston assembly.
1. Install the overdrive servo piston return spring.
2. Install the overdrive servo piston assembly.
2. Use the special tool to install the overdrive servo piston retaining ring.
3. Install the main control valve body. For additional information, refer to Main Control Valve Body in this section.
Reverse Servo Assembly
Special Tool(s) Dial Indicator Gauge with Holding Fixture 100-002 (TOOL-4201-C) Remover/Installer, Servo Piston 307-251 (T92P-70023-A) Installer, Servo Pisto ...1-2 Accumulator
Removal 1. Compress the 1-2 accumulator cover and remove the accumulator piston retaining ring. 2. NOTE: Note the location of the 1-2 accumulator springs for reference during assembly. Remove the ...Other materials:
Assembly
1. NOTE: Universal joint kits are to be installed as complete
assemblies only. Do not mix
components from other U-joint kits.
Install the spider.
1. Start a new bearing cup into the driveshaft yoke.
Check the needle bearings for correct positioning.
...
Vacuum Control Motor - Air Damper Door
Removal
1. Remove the instrument panel. For additional information, refer to Section.
2. Disconnect the vacuum hose.
3. Remove the vacuum control motor.
1. Remove the steel clip.
2. Loosen the nuts.
Installation
1. To install, reverse the removal proc ...
Air Conditioning Line (Peanut) Fitting
Disconnect
1. CAUTION: Support the female fitting with a wrench to prevent the
tubes from
twisting.
Remove the nut from the peanut fitting.
2. Pull the peanut fitting apart.
3. CAUTION: Do not use metal tools to remove the O-ring seal. They can
cause axi ...