Ford Mustang (1999-2004) Service Manual: Pedal and Bracket
Removal
1. Disconnect the battery ground cable (14301).
2. Remove the stoplight switch retaining pin.
3. Slide the stoplight switch (13480) and booster push rod from the brake pedal pin.
4. Remove the brake pedal bracket retaining bolt.
5. Remove the brake pedal bracket retaining nuts.
6. Remove the brake pedal and bracket.
Installation
1. To install, reverse the removal procedure.
Hydraulic Brake Actuation (Description and Operation)
CAUTION: Blistering or swelling of rubber brake components may indicate contamination of the brake fluid by a petroleum based substance. New rubber components must be installed in the hydr ...Master Cylinder
Removal 1. Disconnect the fluid level sensor connector. 2. Disconnect the brake tubes. 3. Remove the brake master cylinder nuts. 4. Remove the brake master cylinder (2140). Installation 1. To ...Other materials:
Camber Adjustment - Rear
1. Loosen the nut.
2. Rotate the bolt and the cam to the correct camber setting.
3. Tighten the nut while holding the bolt and the cam stationary.
4. Recheck the wheel alignment. Follow the manufacturer's instructions.
Adjust as necessary. ...
Crankshaft Front Seal
Special Tool(s)
Installer, Front Cover Oil Seal
303-335 (T88T-6701-A)
Installer, Crankshaft Front Oil
Seal
303-474 (T94P-6701-AH)
Remover, Oil Seal
303-409 (T92C-6700-CH)
Material
Removal
1. Remove the crankshaft pulley. ...
Door Speaker - Lower
Removal and Installation
1. Remove the front door trim panel (239420). For additional
information, refer to Section
2. Remove the speaker (18808).
1. Remove the screws.
2. Disconnect the electrical connector.
3. Remove the speaker.
3. ...