Ford Mustang (1999-2004) Service Manual: Piston
Special Tool(s)
Piston Pin Tool or equivalent 303-D034 (D81L-6135-A) |
Material
Item | Specification |
SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP or equivalent | WSS-M2C153- H |
Disassembly
1. Using the special tool, press the piston pin out from the connecting rod and piston assembly.
2. Remove the connecting rod from the piston.
3. Clean and inspect the connecting rod and piston.
Assembly
1. Lubricate the piston pin and piston pin bore with clean engine oil.
2. NOTE: The connecting rod can be installed in either direction.
Position the piston pin in the bore aligned with the connecting rod bore.
3. Using the special tool, press the piston pin into the piston and rod assembly.
Cylinder Head
Special Tool(s) Compressor, Valve Spring 303-163 (T81P-6513-A) Material Item Specification SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP or equivalent WSS- ...Engine (Assembly)
Special Tool(s) Slide Hammer 307-005 (T59L-100-B) Remover Adapter, Vibration Damper 303-176 (T82L-6316-B) Installer, Crankshaft Front Seal 303-474 (T94P-6701 ...Other materials:
Removal
NOTE: This procedure applies to both the LH and RH halfshafts.
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorber relative to the protective sleeve.
During installation, raise the suspension to this reference ...
Extension Housing
Special Tool(s)
Installer, Bearing Cup
204-039 (T77F-1217-B)
Adapter for 303-224 (Handle)
205-153 (T80T-4000-W)
Disassembly and Assembly
1. Remove the bolt and the output shaft speed (OSS) sensor.
2. Remove the bolt a ...
Removal
1. CAUTION: The vehicle must be on level ground and at curb height.
Mark the rear shock absorbers relative to their protective sleeve.
During installation, raise the suspension to this reference mark before
tightening the
suspension component fasteners.
...