Ford Mustang (1999-2004) Service Manual: Piston - Pin to Bore Diameter
1. WARNING: Cover the end of the pin bore with a hand or shop rag when removing the retainer ring, since it has a tendency to spring out. Wear eye protection.
NOTE: Piston and piston pins are a matched set and should not be interchanged.
Measure the piston pin bore diameter in two directions on each side. Verify the diameter is within specification.
- If out of specification, install new components as necessary.
Piston -Diameter
1. Measure the piston diameter 90 degrees from the piston pin at the point indicated.
- If out of specification, install new components as necessary.
Piston -to Cylinder Bore Clearance
1. Subtract the piston diameter from the cylinder bore diameter to find the piston-to-cylinder bore clearance.
Piston Inspection
Special Tool(s) Scraper, Piston Ring Groove 303-D033 (D81L-6002-D) or equivalent CAUTION: Do not use a caustic cleaning solution or a wire brush to clean the pistons or damage can o ...Piston - Selection
NOTE: The cylinder bore must be within the specifications for taper and out-of-round before fitting a piston. 1. Select a piston size based on the cylinder bore. 2. NOTE: For precision fit, new ...Other materials:
Steering System (Diagnosis and Testing)
Special Tool(s)
Dial Thermometer 0-220F
023-R0007 or Equivalent
Hand Held Automotive Meter
105-R0053 or Equivalent
Power Steering Analyzer
211-F001 (014-00207) or
Equivalent
Spring Scale
211-034 (T74P-3504-Y)
...
Inspection and Verification
1. Verify the customer's concern by operating the active restraint system to
duplicate the condition.
2. Inspect to determine if any of the following mechanical or electrical
concerns apply:
Visual Inspection Chart
Mechanical
Electrical
...
Camshaft Runout
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
1. NOTE: Camshaft journals must be within specifications before
checking runout.
Use a Dial Indicator Gauge with Holding Fixture to measure the ...