Ford Mustang (1999-2004) Service Manual: Planetary Gear Support Assembly and Planetary One-Way Clutch
Disassembly and Assembly
1. NOTE: Inspect the outer and inner races for scores or damaged surface areas where rollers contact the races. Inspect the rollers and springs for excessive wear or damage. Inspect the spring and cage for bent or damaged spring retainers.
Rotate the center support counterclockwise and lift to remove the planetary gear support.
2. Remove the planetary one-way clutch.
3. To assemble, reverse the disassembly procedure
Assembly
1. Inspect the clutch cylinder thrust surfaces, piston bore and clutch plate serrations for scores or burrs. Minor scores or burrs may be removed with crocus cloth. Install a new clutch cylinder if ...Reverse Sun Gear
Disassembly 1. Remove the reverse clutch sun gear assembly and the No. 4 forward clutch hub bearing and race. 2. Remove the forward clutch sun gear assembly and the No. 5 forward clutch ...Other materials:
Rear Drive Axle and Differential
The differential housing (4010) consists of a cast aluminum housing and
a cast aluminum
differential housing cover (4033). The differential housing cover uses
silicone sealant as a
gasket.
The hypoid-design gearset consists of a 8.8-inch ...
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of mechanical and electrical damage.
Visual Inspection Chart
Mechanical
Electrical
Fuel tank
Engine coolant level
Accessory drive belt
Engine oil level
Par ...
Accelerator Pedal and Shaft
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and
shaft arm.
2. Remove the accelerator pedal and shaft.
Remove the nuts.
Remove the accelerator pedal and shaft.
3. To install, reverse the removal pro ...