Ford Mustang (1999-2004) Service Manual: Power Brake Actuation
Torque Specifications
- Brake Booster - Vacuum (Description and Operation)
- Brake Booster - Hydro-Boost (Description and Operation)
- Hydro-Boost Bleeding
- Brake Booster - Vacuum (Removal and Installation)
- Brake Booster - Hydro-Boost (Removal and Installation)
Control Valve
Removal
1. Disconnect the brake tubes.
2. Remove the brake fluid control valve bracket nut.
Installation
1. To install, reverse the removal procedure.
...
Brake Booster - Vacuum (Description and Operation)
Power Brake Booster
The vacuum type power brake booster (2005):
is a dual diaphragm, vacuum assisted power brake booster
reduces brake pedal force and travel distance.
is located on ...
Other materials:
Exhaust Manifold - LH
Removal
1. Raise and support the vehicle. For additional information, refer to
Section.
2. Remove the LH exhaust manifold flange nuts.
3. Remove the RH exhaust manifold flange nuts.
4. Lower the vehicle.
5. NOTE: Discard the exhaust manifold gasket.
...
Starter Drive and Flywheel Ring Gear Inspection
1. Remove the starter motor. For additional information, refer to Starter
Motor-3.8L or Starter
Motor-4.6L in this section.
2. Check the wear patterns on the starter drive gear and the flywheel ring
gear . If the wear pattern
is normal, install the sta ...
Assembly
Initial assembly
1. Coat the new differential drive pinion bearing cup(s) with lubricant.
Use SAE 75W-140 High Performance Rear Axle Lubricant F1TZ-19580-B or
equivalent
meeting Ford specification WSL-M2C192-A.
2. Using the special tool, install the diff ...
