Ford Mustang (1999-2004) Service Manual: Pulley - CII Pump
Special Tool(s)
Pump Pulley Installer 211-009 (T65P-3A733-C) | |
Pump Pulley Remover 211-016 (T69L-10300-B) |
Removal
1. Remove the drive belt.
2. Using the special tool, remove the pulley.
Installation
1. Using the special tool, install the pulley.
2. Install the drive belt.
Pump - CIII
Special Tool(s) Teflon Seal Replacer Set 211-D027 (D90P-3517-A) or equivalent Removal and Installation 1. Remove the pulley. For additional information, refer to Pulley-CIII Pump in ...Pulley - CIII Pump
Special Tool(s) Pump Pulley Replacer 211-185 (T91P-3A733-A) Pump Pulley Remover 211-016 (T69L-10300-B) Removal 1. Remove the drive belt. 2. Raise and support the vehicle. 3 ...Other materials:
Disassembly
1. NOTE: The index mark on the output shaft must be aligned with the
index mark on the output
shaft ring gear during the assembly procedure.
Remove the ring gear snap ring.
2. Separate the ring gear and output shaft.
3. Remove the three output shaft seal ...
Assembly
1. NOTE: Universal joint service kits are to be installed as complete
assemblies only. Do not mix
components from other U-joint kits.
Install the bearing cup.
1. Start a new bearing cup into the driveshaft yoke.
Check the needle bearings for correct po ...
Disassembly
1. Remove the differential assembly from the differential housing. For
additional information, refer
to Differential Case in this section.
2. Remove the bolts.
3. CAUTION: Do not damage the threads in the bolt holes.
Insert a punch in the bolt holes and d ...