Ford Mustang (1999-2004) Service Manual: Pulley - CIII Pump
Special Tool(s)
Pump Pulley Replacer 211-185 (T91P-3A733-A) | |
Pump Pulley Remover 211-016 (T69L-10300-B) |
Removal
1. Remove the drive belt.
2. Raise and support the vehicle.
3. Using the special tool, remove the pulley.
- Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard and install a new pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub.
Installation
1. Using the special tool, install a new pulley.
2. Install the drive belt.
3. Lower the vehicle.
Pulley - CII Pump
Special Tool(s) Pump Pulley Installer 211-009 (T65P-3A733-C) Pump Pulley Remover 211-016 (T69L-10300-B) Removal 1. Remove the drive belt. 2. Using the special tool, remove ...Hose
Special Tool(s) Installer Set, Teflon Seal 211-D027 (D90P-3517-A) or equivalent Removal and Installation CAUTION: While servicing the power steering system, make sure to plug all op ...Other materials:
Push Rods - Inspection
1. CAUTION: Do not attempt to straighten push rods.
Check the ends of the push rods for nicks, grooves, roughness or
excessive wear. Install new
push rods as necessary. Refer to the appropriate section in Group 303 for
the procedure.
The push rods ca ...
Seats (Diagnosis and Testing)
Refer to Wiring Diagrams Cell 120 , Power Seats for schematic and
connector information.
Refer to Wiring Diagrams Cell 122 , Power Lumbar Seats for schematic and
connector information.
Special Tool(s)
73 III Automotive Meter
105-R0057
In ...
Ignition Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the lower instrument panel steering column cover.
1. Remove the screws.
2. Remove the lower instrument panel steering column cover.
3. Remove the instrument panel reinforcement.
1. Rem ...