Ford Mustang (1999-2004) Service Manual: Range Selection
The transmission has six range positions: P, R, N, (D), 2 and 1.
Park
In the PARK position:
- there is no powerflow through the transmission.
- the parking pawl locks the output shaft to the case.
- the engine can be started.
- the ignition key can be removed.
Reverse
In the REVERSE position:
- the vehicle can be operated in a rearward direction, at a reduced gear ratio.
- engine braking will occur.
Neutral
In the NEUTRAL position:
- there is no powerflow through the transmission.
- the output shaft is not held and is free to turn.
- the engine can be started.
Overdrive
Overdrive is the normal position for most forward driving.
The OVERDRIVE position provides:
- Automatic shifts.
- Apply and release of the torque converter clutch.
- Maximum fuel economy during normal operation.
Second Position
This position provides:
- Second gear start and hold.
- The torque converter clutch can apply and release.
- Improved traction and engine braking on slippery roads.
- Engine braking for descending steep grades.
First Position
If this position is selected at normal road speeds, the transmission will shift into second gear, then into first when the vehicle reaches a speed below approximately 45 km/h (28 mph).
This position provides:
- First gear operation only.
- Engine braking for descending steep grades.
Identification Tags
All vehicles are equipped with a Vehicle Certification Label, located on the driver side door lock post. For correct transmission identification, refer to the code in the space marked TR. ...Shift Patterns
Upshifts Transmission upshifting is controlled by the powertrain control module (PCM). The PCM receives inputs from various engine or vehicle sensors and driver demands to control shift sche ...Other materials:
Weld Nut Repair - "J" Nut, Restraints Control
Module
(RCM)
WARNING: To avoid accidental deployment and possible personal
injury, the backup
power supply must be depleted before repairing or replacing any front or
side air bag
supplemental restraint system (SRS) components and before servicing,
replacing, ...
Air Bag Supplemental Restraint System (SRS) (Description and Operation)
The air bag supplemental restraint system (SRS) is designed to provide
increased collision protection
for front seat occupants in addition to that provided by the three-point safety
belt system. Safety belt
use is necessary to obtain the best occupant protec ...
Key Release Button
Removal
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and
turn to RUN position.
2. Push the ignition switch lock cylinder release tab with a p ...