Ford Mustang (1999-2004) Service Manual: Rear Bumper Cover
Removal and Installation
1. Remove the luggage compartment trim panel covers.
2. Remove the seven rear bumper cover nuts.
3. Remove the fuel drain hose.
4. Remove the four bumper cover screws (two each side).
5. Remove the pin-type retainers and the rear bumper cover.
6. To install, reverse the removal procedure.
Front Bumper Cover
Removal and Installation NOTE: Mustang shown, GT and Cobra similar. 1. Remove the pin-type retainers and the radiator upper sight shield. 2. Remove the two pin-type retainers (one each side). 3. R ...Front Bumper
Special Tool(s) Heavy-Duty Riveter 501-D011 (D80L-23200-A) Removal and Installation All vehicles except Cobra 1. Remove the front bumper cover. For additional information, refer to Fro ...Other materials:
Pinpoint Test K: LFC 35/DTC B1935 - Passenger Air Bag Circuit Resistance
Low
Normal Operation
The restraints control module (RCM) monitors the resistance of the
passenger air bag ignitor by
measuring the resistance between pins 6 and 7. If the RCM detects low
resistance between these
pins, it will store a diagnostic trouble code ...
Cabin air filter
Note: Make sure you have a cabin air filter installed at all times.
This
prevents foreign objects from entering the system. Running the system
without a filter in place could result in degradation or damage to the
system.
Your vehicle is equipped with a cabi ...
Shift Point Road Test
This test verifies that the shift control system is operating
correctly.
1. Bring engine and transmission up to normal operating temperature.
2. Operate vehicle with transmission range selector lever in (D)
position.
3. NOTE: Shift speed ranges a ...