Ford Mustang (1999-2004) Service Manual: Rear Drive Axle/Differential - Ford 7.5-Inch Ring Gear
General Specifications
a: In-vehicle repair refill capacities are determined by filling the rear axle with the specified lubricant to 6.4-14.3-mm (1/4-9/16-in) below the bottom of the fill hole.
Torque Specifications
- Axle Shaft
- Drive Pinion Flange and Drive Pinion Seal
- Differential Housing Cover
- Axle Housing Bushing
- Drive Pinion
- Axle Assembly
- Differential Case and Ring Gear
Assembly
1. NOTE: Universal joint kits are to be installed as complete assemblies only. Do not mix components from other U-joint kits. Install the spider. 1. Start a new bearing cup into the driveshaft yok ...Other materials:
Pinpoint Test I: LFC 33/DTC B1933 - Passenger Air Bag Circuit Resistance
High
Normal Operation
The restraints control module (RCM) monitors the resistance of the
passenger air bag ignitor by
measuring the resistance between pins 6 and 7. If the RCM detects high
resistance between these
pins, it will store a diagnostic trouble cod ...
Instrument Cluster Replacement
When it is necessary to install a new instrument cluster, contact the
Instrument Cluster Program.
Gauge Indication Systems
Tachometer
Engine rpm information is relayed to the instrument cluster from the
powertrain control module (PCM)
over the standard ...
Pinpoint Test B: LFC 21/DTC B1921 - RCM Bracket Ground Resistance High
Normal Operation
WARNING: The tightening torque of the restraints control module
(RCM) retaining bolts is
critical for proper air bag supplemental restraint system (SRS)
operation. Refer to Restraints
Control Module (RCM) in this section for correc ...