Ford Mustang (1999-2004) Service Manual: Rear Subframe
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Torque values must be used as specified during reassembly.
1. Remove the rear coil springs. For additional information, refer to Section.
2. Using the special tool, raise the rear subframe.
3. Remove and discard the rear subframe front bolts.
4. Using the special tool, lower and remove the rear subframe.
5. NOTE: Discard the old bolts and nuts. Do not reuse, install new bolts and nuts.
To install, reverse the removal procedure.
Subframe Support -Convertible
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to Section.
2. Support the front subframe support.
3. Remove the RH front subframe support bolts.
4. Remove the LH front subframe support bolts.
5. Remove the front subframe support.
- Remove the bolts and lower the front subframe support.
6. To install, reverse the removal procedure.
Front Subframe - 4.6L (4V) Engine
Special Tool(s) 3-Bar Engine Support Kit 303-F072 Lifting Bracket, Engine 303-D088 (D93P-6001-A2) Removal and Installation All vehicles 1. Remove the steering gear. For a ...General Information
INTRODUCTION In the past, when cars were simpler, diagrams were simpler. All components were connected by wires, and diagrams seldom exceeded 4 pages in length. Today, some wiring diagrams require m ...Other materials:
Cleaning the engine
Engines are more efficient when they are clean because grease and dirt
buildup keep the engine warmer than normal.
When washing:
• Take care when using a power washer to clean the engine. The
high-pressure fluid could penetrate the sealed parts and cause
da ...
Cylinder Head Temperature (CHT) Sensor - 3.8L
Removal
1. Disconnect the battery ground cable. For additional information
refer to Section.
2. Disconnect the cylinder head temperature sensor connector.
3. Remove the CHT sensor.
Installation
1. To install, reverse the removal procedure. ...
Accessory Drive - Cobra
Component Locations -Supercharger Accessory Drive
Component Location -Accessory Drive
...