Ford Mustang Service Manual: Rear Wheel Bearing and Axle Shaft Oil Seal

Rear Drive Axle and Differential

 


 



  • The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The differential housing cover uses silicone sealant as a gasket.
  • The hypoid-design gearset consists of 7.5-inch ring gear (4209) and a drive pinion gear (4209).

    Two opposed tapered roller bearings support the drive pinion in the axle housing (4010).

  • A collapsible spacer (4662), located on the differential pinion shaft, maintains pinion bearing preload. The pinion nut adjusts the preload.
  • Differential bearing shims (4067), located between the differential bearing cups (4222) and the rear axle housing, adjust the differential bearing preload and the ring gear backlash.
  • The differential case (4204) is a one-piece design with two openings to allow for assembly of the internal components and lubricant flow. Two opposed tapered roller bearings (differential bearings) (4221) support the differential case in the axle housing. Removable bearing caps (4010) retain the differential assembly in the axle housing.
  • Inside the differential case, the differential pinion shaft (4211) supports two differential pinion gears (4215). The pinion gears engage the differential side gears (4236), to which the axle shafts (4234) are splined. The differential pinion shaft lock bolt (4241) retains the differential pinion shaft in the differential case.
  • An embossed metal tag, bolted to the differential housing cover, contains rear axle identification.
    Installation
    Removal 1. Raise and support the vehicle. 2. Remove the wheel and tire assembly. 3. Remove the rear brake disc (2C026). 4. Remove the differential housing cover (4033) and drain the lubricant. F ...

    Drive Pinion Flange and Drive Pinion Seal
    Rear Drive Axle and Differential   The axle housing assembly consists of a cast center section with two steel tube assemblies and a stamped differential housing cover (4033). The diffe ...

    Other materials:

    Oil Pan Baffle
    Engine Component View Cylinder Heads and Valve Train Components   Engine Front Cover Components   Engine Components   Cylinder Block and Lower End Components   Engine (DIAGNOSIS AND TESTING) Refer to Section for basic mecha ...

    Audio Unit (Removal and Installation)
    Audio Unit (Removal and Installation) Removal and Installation 1. Remove the instrument panel center finish panel. For additional information, refer to Section 2. Remove the audio unit. 1. Remove the screws. 2. Disconnect electrical connecto ...

    Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube
    Engine Emission Control (Description and Operation) CAUTION: Do not remove any part of the engine emission control system. Operating the engine without the engine emission control system will reduce fuel economy and engine ventilation. This will weaken engin ...