Ford Mustang (1999-2004) Service Manual: Release Cable - Clutch
Removal
CAUTION: Whenever the clutch release lever cable (7K553) is disconnected for any reason, such as transmission removal, clutch pedal components or clutch release lever cable replacement, it is imperative the correct method for installing the clutch release lever cable be followed. Incorrect installation may damage components or cause system failure.
1. Remove the instrument panel steering column cover.
1. Remove the screws.
2. Remove the instrument panel steering column cover.
2. Remove the instrument panel reinforcement.
1. Remove the screws.
2. Remove the instrument panel reinforcement.
3. Lift the clutch pedal (7519) to its most upward position.
4. Remove the front seat. For additional information, refer to Section.
5. Unhook the clutch release lever cable (7K553) from the clutch pedal adjuster quadrant (7L583).
6. Open the hood, remove the screws and the clutch release cable (7K553).
7. NOTE: On 4.6L vehicles only Remove the bolt and the clutch release lever cable bracket from the brake master cylinder (2140).
8. Raise the vehicle. For additional information, refer to Section.
9. Remove the screw from the clutch release lever cable clamp.
10. Remove the screw and the dust shield.
11. Pull the clutch release lever cable (7K553) and remove from the clutch release lever (7515).
12. Remove the C-clip from the clutch release lever cable and remove the clutch release lever cable from the vehicle.
Installation
1. To install, reverse the removal procedure.
Clutch Pedal - Quadrant and Pawl Assembly
Removal 1. Disconnect the battery ground cable (14301). 2. Loosen the nut from inside the engine compartment. 3. Loosen the nuts from inside the vehicle. 4. Loosen the screw. 5. Disconnect t ...Manual Transaxle/Transmission - T5OD
General Specifications Torque Specifications ...Other materials:
Selector Lever
Removal
1. Remove the shifter top control panel.
2. Disconnect the electrical connectors.
3. Remove the shifter bezel.
4. Remove the bulb from the bezel.
5. Disconnect the TCS connector.
6. CAUTION: Extra force may be needed to lift up on the handl ...
Final assembly
23. Install the differential assembly in the differential housing. For
additional information, refer to
Differential Case in this section.
24. CAUTION: Align the index marks.
CAUTION: Install the driveshaft with new bolts. If new bolts are not available,
a ...
Front Bumper Cover
Removal and Installation
NOTE: Mustang shown, GT and Cobra similar.
1. Remove the pin-type retainers and the radiator upper sight shield.
2. Remove the two pin-type retainers (one each side).
3. Remove the four front bumper cover nuts (two each side).
4. ...