Ford Mustang (2005-2014) Owners Manual: Remote control

Integrated Keyhead Transmitters

The key blade is used to start the vehicle and unlock or lock the driver’s door from outside the vehicle. The transmitter portion functions as the remote control.

Note: If the vehicle is not equipped with active anti-theft system, locking the driver door with the key does not lock the passenger door. Use the power door lock, remote control or manually lock the passenger door to ensure the vehicle is properly secured.

Note: Your vehicle’s keys were issued with a security label that provides important vehicle key cut information. Keep the label in a safe place for future reference.

Car Finder

Press the button twice within three seconds. The horn will sound and the turn signals will flash. We recommend you use this method to locate your vehicle, rather than using the panic alarm.

Sounding a Panic Alarm

Press the button to activate the alarm. Press the button again or switch the ignition on to deactivate.

Note: The panic alarm will only operate when the ignition is off.

Replacing the Battery

Note: Refer to local regulations when disposing of transmitter batteries.

Note: Do not wipe off any grease on the battery terminals or on the back surface of the circuit board.

Note: Replacing the battery will not delete the transmitter from your vehicle. The transmitter should operate normally.

The remote control uses one coin-type three-volt lithium battery CR2032 or equivalent.

Integrated Keyhead Transmitter

1. Twist a thin coin in the slot near the key ring to remove the battery cover (1).
2. Carefully peel up the rubber gasket (2) from the transmitter if it does not come off with the battery cover.
3. Remove the old battery (3).
4. Insert the new battery. Refer to the instructions inside the integrated keyhead transmitter for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity.
5. Reinstall the rubber gasket.
6. Snap the battery cover back onto the key.

    General information on radio frequencies
    This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful ...

    Replacing a lost key or remote control
    You can purchase replacement or additional keys or remote controls from an authorized dealer. A dealer can program the transmitters to your vehicle or you may be able to program them yourself. See the ...

    Other materials:

    Transmission Cooling - Integral
    This vehicle with an automatic transmission is equipped with an integral transmission fluid cooler. The cooler is contained inside of the radiator outlet tank and cannot be serviced separately. The cooler transfers heat from the transmission fluid to the eng ...

    Engine - 4.6L (2V)
    General Specifications a - With installation of a new filter. b - Distance front edge of bearing is installed below front face of cylinder block. c - Time necessary for plunger to leak down 1.6 mm of travel with 222 N force and leak down fluid in tap ...

    Engine (Assembly)
    Special Tool(s) Guides, Connecting Rod 303-442 (T93P-6136-A) Installer, Crankshaft Rear Oil Seal 303-518 (T95P-6701-DH) Installer, Crankshaft Rear Oil Seal 303-516 (T95P-6701-BH) Installer, Crankshaft Re ...