Ford Mustang (1999-2004) Service Manual: Removal
1. Remove the A/C compressor (19703). For additional information, refer to Air Conditioning (A/C) Compressor-3.8L or Air Conditioning (A/C) Compressor-4.6L in this section.
2. Remove the bolt.
1. Hold the A/C disc and hub assembly (19D786) with the special tool.
2. Remove the bolt.
3. Remove the A/C disc and hub assembly and spacer (19D648).
1. Thread an 8 x 1.25 mm (0.05 in) bolt into the A/C disc and hub assembly to force it from the compressor shaft.
2. Lift the A/C disc and hub assembly and spacer from the compressor shaft.
4. Using the special tool, remove the shaft seal felt from the nose of the A/C compressor.
5. Clean the compressor nose area.
6. Insert the tip of the special tool into one of the snap ring eyes.
7. Rotate the special tool to position the tool tip and the snap ring eye closest to the A/C compressor shaft.
8. Pull the special tool up quickly while keeping the tool shaft against the side of the nose opening and remove the snap ring.
9. Engage the special tool into the inside diameter of the shaft seal.
10. Turn the tool handle clockwise to expand the tool tip inside the shaft seal.
11. Pull the seal from the A/C compressor.
Air Conditioning (A/C) Compressor Shaft Seal
Special Tool(s) Holding Fixture, Compressor Clutch (3.8L vehicles) 412-098 (T94P-19703-AH) Holding Fixture, Compressor Clutch (4.6L vehicles) 412-103 (T95L-19703-AH) ...Installation
1. CAUTION: To prevent refrigerant system contamination, do not allow dirt or other foreign materials to enter the A/C compressor. Clean the A/C compressor nose area. 2. Place the shaft seal on the s ...Other materials:
Component Test
Carry out the appropriate Functional Test(s) as determined in Inspection and
Verification.
Functional Test I (Buckle and Tongue)
The safety belt buckle and tongue assembly must operate freely during the
latching and unlatching
function. Fasten the safety bel ...
Door Speaker - Lower
Removal and Installation
1. Remove the front door trim panel (239420). For additional
information, refer to Section
2. Remove the speaker (18808).
1. Remove the screws.
2. Disconnect the electrical connector.
3. Remove the speaker.
3. ...
Disc and Pressure Plate - 4.6L (4V) Engine
Special Tool(s)
Clutch Aligner
308-020 (T74P-7137-K)
Material
Item
Specification
Premium Long Life Grease
XG-1-C
ESA-M1C75-B
1. Disconnect the battery ground cable. For additional information, refer to
Section.
2. Remove t ...