Ford Mustang (1999-2004) Service Manual: Removal
1. Remove the center instrument panel register. 2. Remove the screws.
3. Disconnect the connectors.
4. Using the special tool, disconnect the temperature control cable from the control head.
5. Remove the nuts and disconnect the vacuum connector.
Control Assembly
Special Tool(s) Remover, Heater Control Cable Retainer 412-088 (T94P-18532-A) ...Installation
1. Align the blend door driver to the full heat position. 2. Place the temperature control knob in the full WARM position. 3. Attach the cable drive to the control head. 4. Rotate the knob back ...Other materials:
Key Programming - Additional Key With One Programmed
Key
Special Tool(s)
Worldwide Diagnostic System
(WDS)
418-F224,
New Generation STAR (NGS)
Tester
418-F052, or equivalent
diagnostic tool
NOTE: This procedure is used when a customer needs to have an additional key
programmed into the
veh ...
Spindle
Special Tool(s)
Tie-Rod End Remover
211-001 (TOOL-3290-D) or
Equivalent
Removal
CAUTION: Suspension fasteners are critical parts because they affect
performance of vital
components and systems and their failure can result in major service expen ...
Multifunction Electronic Control Modules
Torque Specifications
Module Controlled Functions
The generic electronic module (GEM)(14B205) is the only multifunction
control module on this vehicle.
The GEM controls the following functions:
warning chimes and warning lamps
one-touch down ...