Ford Mustang (1999-2004) Service Manual: Removal
1. Remove the rear defrost connectors if necessary.
2. Remove the nuts retaining the well sling and convertible top tacking strips.
3. Remove the three tacking strips.
4. Mark the top of the convertible top skin around the top of all three tacking strips with a grease pencil.
5. Remove the visible staples.
6. Remove the water diverter.
7. Mark the winter seal at the top, bottom and the forward edge of the rear tacking strip.
8. Remove the winter seal.
9. Lift the rear cover assembly over the convertible top exposing the top of the rear window glass assembly.
10. Remove all of the staples in the cover assembly along the number four bow.
11. Remove all of the staples in the rear window glass assembly along the number four bow.
12. Remove the rear window glass assembly.
Installation
1. Overlay the new rear window glass assembly over the old rear window glass assembly and transpose the markings with a grease pencil. 2. Center the V-notch on the new rear window glass assemb ...Other materials:
Front Subframe - 4.6L (2V) Engine
Special Tool(s)
Support Bar, Engine
303-290-A
Lifting Bracket, Engine
303-D088 (D93P-6001-A2)
Removal and Installation
All vehicles
1. Remove the steering gear. For additional information, refer to Section.
2. Remove the lower co ...
Master Cylinder Priming - 4.6L
1. CAUTION: Use only bleed screws on the engine side of the
brake master cylinder
(2140). The hydro-boost bleed screw, located near the dash on the
hydro-booster
casting, is for the booster cavity filled with power steering fluid, not
brake fluid. ...
Clutch Pedal Position (CPP) Switch
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Disconnect the connector.
3. Remove the bolt and the clutch pedal position (CPP) switch.
Installation
1. To install, reverse the removal procedure. ...