Ford Mustang (1999-2004) Service Manual: Removal
NOTE: The convertible top hydraulic components are removed from the vehicle as an assembly. The hydraulic components are individually repaired and the system must be bled before being installed into the vehicle.
Hydraulic system
1. Unlatch the convertible top.
2. Remove the rear quarter trim panel. For additional information, refer to Section.
3. NOTE: This step applies to vehicles equipped with the Mach sound system.
Remove the screw and disconnect the electrical connectors.
4. Remove the screws.
5. Remove the speakers.
6. Remove the two cylinder rod mounting bolts.
7. Fully lower the lift cylinders.
8. Remove the nuts and the lift cylinders.
9. Release the hydraulic line retainers on each side.
10. Disconnect the motor electrical connector.
11. Pull up on the motor to release the rubber retainers.
12. Remove the motor and cylinders as an assembly.
Lift cylinder
13. NOTE: Prior to their removal, mark the upper and lower hydraulic lines to insure correct installation on the new cylinder.
Remove the hydraulic lines from the cylinder.
Motor assembly
14. NOTE: Prior to removal, mark the hydraulic lines to insure correct installation of the motor assembly.
Remove the hydraulic lines from the motor assembly.
Installation
Lift cylinder 1. NOTE: Be sure that each fitting is installed in the correct position on the folding top hydraulic component. NOTE: Make sure that the tetra seal is installed in the bottom of each of ...Other materials:
Engine System - General Information
General Specifications
Engine
NOTE: This section contains information, steps and procedures that may
not be specific to your
engine.
This section covers general procedures and diagnosis and testing of the engine
system, except for
exhaust emission control ...
Exhaust Gas Recirculation (EGR) Vacuum Regulator
Solenoid
Mach I vehicles
1. Remove the air intake scoop. For additional information, refer to
Section .
All vehicles
2. Remove the exhaust gas recirculation (EGR) vacuum regulator solenoid.
Disconnect the electrical connector.
Remove the bolts.
3. To ins ...
Valve Tappets
Material
Removal
CAUTION: If removing more than one valve tappet, mark the
components removed for
correct location.
1. Remove the lower intake manifold. For additional information, refer to
Lower Intake Manifold in
this section.
2. Remove the push r ...