Ford Mustang (1999-2004) Service Manual: Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. Remove the rear wheel knuckle (5A968/5A969). For additional information, refer to Wheel Knuckle-Cobra in this section.
2. Remove the bolts and the dust shield. Discard the bolts.
3. Position the knuckle in a vise.
4. NOTE: There are two methods for removing the rear hub (1109) from the rear wheel bearing (1A049). Both methods are shown.
Method one. Using the special tools, remove the hub.
5. Method two. Using the special tools, remove the hub.
6. Remove the snap ring.
7. Press the wheel bearing from the knuckle.
1. Position the knuckle on the press bed supported by the special tool.
2. Using the appropriate step plate adapter, press the bearing from the knuckle.
Wheel Hub - Cobra
Special Tool(s) 2-3 Jaw Puller 205-D026 (D80L-1013-A) or Equivalent Driver 205-199 (T83T-3132-A1) Front Hub Remover Replacer 204-069 (T81P-1104-C) ...Installation
1. Install the bearing. 1. Position the knuckle on the press. 2. Using the appropriate step plate adapter, press the bearing into the knuckle until the bearing clears the snap ring groove and b ...Other materials:
Running out of fuel
Avoid running out of fuel because this situation may have an adverse
effect on powertrain components.
If you have run out of fuel:
• You may need to cycle the ignition from off to on several times after
refueling to allow the fuel system to pump the fuel fr ...
Brake Caliper Anchor Plate - Cobra
Removal
1. Remove the pads. For additional information, refer to Brake
Pads-Cobra in this section.
2. Remove the anchor plate bolts.
Installation
1. Follow the removal procedure in reverse order.
...
Component Tests
Steering Linkage
1. NOTE: Excessive vertical motion of the studs relative to the
sockets may indicate excessive
wear.
With the parking brake applied, perform the following:
Have an assistant rotate the steering wheel back and forth 360 degrees
and watch ...