Ford Mustang (1999-2004) Service Manual: Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Mark the rear shock absorber (18125) relative to the protective sleeve with the vehicle in a static, level ground position (curb height).

Upper Arm

2. Raise the vehicle on a hoist.

3. Support the differential housing with a jack stand.

4. Disconnect the upper arm and bushing (5500) from the axle.

1. Remove and discard the nut and bolt.

2. Disconnect the arm and bushing from the axle.

Upper Arm

5. Remove the upper arm and bushing from the mounting bracket.

1. Remove and discard the nut and bolt.

2. Remove the arm and bushing.

Upper Arm

    Upper Arm
    ...

    Installation
    1. Install the upper arm and bushing to the mounting bracket. 1. Position the arm and bushing. 2. Install a new nut and bolt. Do not tighten at this time. 2. Connect the upper arm and bushing to ...

    Other materials:

    Sun visors
    Slide-On-Rod Rotate the visor toward the side window and extend it rearward for extra sunlight coverage. Retract the visor before moving it back toward the windshield and storing it. Illuminated Visor Vanity Mirror Lift the cover to switch on the lamp. Flex ...

    Removal
    CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. ...

    2-3 Accumulator
    Removal 1. Remove the main control valve body. For additional information, refer to Main Control Valve Body in this section. 2. Remove the 2-3 accumulator piston retainer. 3. Remove the accumulator piston and spring. Installation 1. Install the 2-3 accum ...