Ford Mustang (1999-2004) Service Manual: Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. Mark the rear shock absorber (18125) relative to the protective sleeve with the vehicle in a static, level ground position (curb height).
2. Raise the vehicle on a hoist. .
3. Remove both wheel and tire assemblies.
4. Remove the rear brake disc.
5. Remove the rear springs (5560). For additional information, refer to Spring-Cobra in this section.
6. Raise the subframe into position and remove the front bolts.
7. Lower the subframe from the vehicle.
8. Mark the cam bolt position relative to the upper suspension arm and bushing (5500).
9. NOTE: Mark a new cam bolt in the same position as the old one for assembly reference before discarding the old bolt.
Disconnect the upper suspension arm and bushing from the knuckle (5A968/5A969).
1. Remove and discard the nut and bolt.
2. Disconnect the upper suspension arm and bushing.
10. Remove the upper suspension arm and bushing.
1. Remove and discard the nuts and bolts.
2. Remove the upper suspension arm and bushing.
Installation
CAUTION: The upper suspension arm and bushing nuts must be tightened with the suspension at curb height. Failure to do so can result in bushing failure, resulting in poor ride and handling. NOTE: If ...Other materials:
Engine Front Cover
Material
Item
Specification
Metal Surface Cleaner
F4AZ-19A536-RA or equivalent
WSE-M5B392-
A
Silicone Gasket and Sealant
F7AZ-19554-EA or equivalent
WSE-M4G323-
A4
SAE 5W-30 Premium Synthetic
Blend Motor Oil
XO-5W30-QSP ...
Anti-Lock Control - Rear
Torque Specifications
Anti-Lock Control
The four wheel anti-lock brake system (4WABS) consists of the following
components:
anti-lock brake control module (2C346)
front anti-lock brake sensor (2C205)
front anti-lock brake sensor indicator (2C182)
...
Removal
1. Remove the center instrument panel register.
2. Remove the screws.
3. Disconnect the connectors.
4. Using the special tool, disconnect the temperature control cable from the
control head.
5. Remove the nuts and disconnect the vacuum connector.
...