Ford Mustang (1999-2004) Service Manual: Removal
1. Use a suitable suction device to lower the brake fluid level in the master cylinder reservoir.
2. Raise and support the vehicle.
3. Remove the wheel and tire assembly.
4. Inspect the pads for wear or contamination, install new if worn to or past specification.
5. CAUTION: Do not allow the rear disc brake caliper (2552) to hang from the rear wheel brake hose (2A442).
Remove the rear disc brake caliper bolts and position the caliper aside.
6. Remove the brake pads.
7. Remove the slippers.
8. CAUTION: Use a hub-mount brake lathe if necessary to machine the brake disc.
Measure the brake disc, resurface and or install new as necessary.
9. Compress the rear disc brake piston and adjuster (2B588) into rear disc brake caliper using Rear Caliper Piston Adjuster.
Pads
Special Tool(s)
Rear Caliper Piston Adjuster
206-026 (T87P-2588-A)
...
Installation
1. CAUTION: Install the brake pads in full axle sets. Do not
install new brake pads on
only one side of vehicle.
Install the new slipper and brake pads.
2. Position the caliper on the anchor ...
Other materials:
Weld Nut Repair - "J" Nut, Restraints Control
Module
(RCM)
WARNING: To avoid accidental deployment and possible personal
injury, the backup
power supply must be depleted before repairing or replacing any front or
side air bag
supplemental restraint system (SRS) components and before servicing,
replacing, ...
Clutch Pedal Position (CPP) Switch
Removal
1. Disconnect the battery ground cable. For additional information,
refer to Section.
2. Disconnect the connector.
3. Remove the bolt and the clutch pedal position (CPP) switch.
Installation
1. To install, reverse the removal procedure. ...
Exceptions To Normal Schedule
Yellow Coolant
Change coolant at 5 years or 160,000 km (100,000 miles) of the vehicle's
life, whichever comes
first.
After the initial change, change coolant every 3 years or 80,000 km
(50,000 miles) thereafter.
Natural Gas and Propane Vehicles
Insp ...
