Ford Mustang (1999-2004) Service Manual: Removal
1. Disconnect the battery ground cable.
2. Remove the air cleaner outlet tube. For additional information, refer to Section.
3. Remove the radiator sight shield.
4. Install the special tool.
5. Using the special tools, support the engine.
6. Raise and support the vehicle. For additional information, refer to Section.
7. Remove the two engine mount nuts.
8. Lower the vehicle.
9. Using the special tool, raise the engine.
10. Raise and support the vehicle. For additional information, refer to Section.
11. Drain the engine oil.
- Remove the oil pan drain plug.
12. Using the special tool, compress the front coil springs.
13. Position a safety stand.
14. Remove the four engine mount bolts.
15. NOTE: Do not completely remove the bolts.
Loosen the front subframe bolts.
16. Lower the front subframe.
17. NOTE: Be careful when removing the oil pan gasket. It may be reusable. Inspect the oil pan gasket for damage.
Remove the oil pan and gasket.
Oil Pan
Special Tool(s) Compressor, Coil Spring 204-D001 (D78P-5310-A) Support Bar, Engine 303-290-A Lifting Bracket, Engine 303-D087 (D93P-6001-A1) Liftin ...Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a p ...Other materials:
Installation
1. Install the upper arm and bushing to the mounting bracket.
1. Position the arm and bushing.
2. Install a new nut and bolt. Do not tighten at this time.
2. Connect the upper arm and bushing to the axle.
1. Position the arm and bushing.
2. Install a ...
Driveline Angle
Item
Description
1
Bottom of the frame
2
Engine crankshaft centerline
3
Engine angle
4
Driveshaft and coupling shaft centerline
5
Driveshaft and coupling shaft angle
6
Rear axle pinion centerline ...
Principles of Operation
The vehicle has two module communications networks. The standard
corporate protocol (SCP) which
is an unshielded twisted pair cable (data bus plus, Circuit 914 [TN/OG] and
data bus minus, Circuit 915
[PK/LB]), and the international standards organization ...