Ford Mustang (1999-2004) Service Manual: Removal

1. Remove the air intake scoop bracket. For additonal information, refer to Section.

2. Remove the air cleaner outlet tube. For additional information, refer to Section.

3. Disconnect the accelerator cable, the speed control actuator cable and the return spring.

Intake Manifold - Upper

4. Remove the bolts, disconnect the clip and position the cables out of the way.

Intake Manifold - Upper

5. Disconnect the throttle position (TP) sensor.

Intake Manifold - Upper

6. Disconnect the evaporative emissions (EVAP) return hose.

Intake Manifold - Upper

7. Disconnect the idle air control valve and the differential pressure feedback EGR.

Intake Manifold - Upper

8. Disconnect the main chassis vacuum supply line and the EGR valve vacuum line.

Intake Manifold - Upper

9. Disconnect the differential pressure feedback EGR hoses.

Intake Manifold - Upper

10. Disconnect the EGR valve to exhaust manifold tube from the EGR valve.

Intake Manifold - Upper

11. Disconnect the electrical connector and the vacuum lines from the EGR vacuum regulator solenoid.

Intake Manifold - Upper

12. Remove the PCV valve-to-intake manifold tube.

Intake Manifold - Upper

13. Remove the upper intake manifold bolts in the sequence shown and remove the intake manifold assembly.

Intake Manifold - Upper

14. Inspect and clean the sealing surfaces.

Intake Manifold - Upper

    Installation
    1. Install the upper intake manifold gasket. 2. Install the intake manifold and bolts in the sequence shown. 3. Install the PCV valve-to-intake manifold tube. 4. Connect the vacuum hoses and ...

    Other materials:

    Power seats
    WARNING: Never adjust the driver’s seat or seat back when the vehicle is moving. WARNING: Before returning the seat back to its original position, make sure that cargo or any objects are not trapped behind the seat back. The power seat control is located on ...

    Disconnect
    1. Remove the A/C tube lock coupling clip (19E746), if equipped. 2. Fit the special tool to the spring lock coupling. 3. Push the tool into the cage opening to release the female fitting from the A/C tube lock coupling spring (19E576). 4. Pull the sprin ...

    Spark Plug Wire
    Special Tool(s) Remover, Spark Plug Wire 303-106 (T74P-6666A) Material Item Specification Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A or equivalent ESE-M1C171- A Removal and Installation CAUTION: ...