Ford Mustang Service Manual: Removal
Removal
All vehicles
1. Remove the air intake scoop. For additional information, refer to Section.
2. Remove the Hydro-Boost brake booster. For additional information, refer to Section..
3. Raise and support the vehicle. For additional information, refer to Section.
Manual transmission vehicles
4. Remove the screw and the dust shield.
5. Disengage the clutch release cable from the clutch release fork.
6. Lower the vehicle.
7. Remove the two screws and position the clutch release cable aside.
All vehicles
8. Remove the LH ignition coil cover bolts and the cover.
9. Disconnect the ignition coil electrical connectors.
10. Remove the ignition coils
11. Remove the bolt and position the oil level indicator tube aside.
12. Disconnect the positive crankcase ventilation (PCV) valve hose and the electrical connector.
13. Disconnect the wiring harness anchor from the valve cover.
14. Remove the LH valve cover.
15. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Clean and inspect the sealing surfaces and the valve cover gaskets. If necessary, install new gaskets. Make sure the gaskets are correctly seated on the valve cover.
Valve Cover LH
Engine WARNING: Do not operate the engine with the hood open until the fan blade has been first examined for possible cracks and separation. The 4.6L (4V) (281 CID) is a V-8 engine with the follow ...Installation
Removal All vehicles 1. Remove the air intake scoop. For additional information, refer to Section. 2. Remove the Hydro-Boost brake booster. For additional information, refer to Section.. 3. Raise a ...Other materials:
Leakage Inspection
Transmission Description (Description and Operation)
The 4R70W has the following features:
Wide ratio gears
Four speeds
Rear wheel drive
Automatic
Electronic shift
Torque converter clutch control
Line pressure controls
The transm ...
Convertible Top Assembly - Rear Window Glass
Convertible Top (Description and Operation)
Rear Window Glass Assembly
The convertible top assembly is equipped with a rear window glass
assembly. The rear window glass
assembly is permanently attached to the folding top rear window curtain
...
Air Cleaner - 4.6L (2V) and 4.6L (4V)
Intake Air Distribution and Filtering - Supercharger,
Charge Air Cooler
The supercharger (SC) is a positive displacement pump. Its purpose is to
supply an excess volume of
intake air to the engine by increasing air pressure and density in the
intake man ...