Ford Mustang (1999-2004) Service Manual: Removal
1. Disconnect the electrical connectors from the EGR vacuum regulator solenoid, the supercharger bypass vacuum solenoid, and the differential pressure feedback EGR system.
2. Disconnect the vacuum hoses from the differential pressure feedback EGR system.
3. Disconnect the vacuum hoses from the supercharger bypass vacuum solenoid, and the actuator.
4. Disconnect the vacuum hoses from the EGR vacuum regulator solenoid.
5. Remove the vacuum accessory bracket mounting nut.
6. Remove the mounting bolts and the vacuum accessory bracket.
7. Remove the actuator mounting bolts.
8. Align the actuator rod with the slot in the actuator linkage, and remove the actuator.
Installation
1. CAUTION: The actuator adjustment tool included with the replacement actuator kit must be used when installing the supercharger bypass vacuum actuator. Failure to correctly adjust the actu ...Other materials:
Module Communications Network
General Specifications
Communications Network
Module Communications Network
...
Engine (Assembly)
Special Tool(s)
Guides, Connecting Rod
303-442 (T93P-6136-A)
Installer, Crankshaft Vibration
Damper
303-102 (T74P-6316-B)
Installer, Front Cover Oil Seal
303-335 (T88T-6701-A)
Installer, Crankshaft Rear ...
Roller Followers
Special Tool(s)
Compressor, Valve Spring
303-452 (T93P-6565-AR)
Removal and Installation
1. Remove the LH and RH valve cover. For additional information, refer to
Valve Cover LH and
Valve Cover RH in this section.
2. Position the piston of t ...