Ford Mustang (1999-2004) Service Manual: Retractor - Front Seat Safety Belt, Convertible

Ford Mustang (1999-2004) Service Manual / Body / Safety Belt System / Retractor - Front Seat Safety Belt, Convertible

Special Tool(s)

Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A)

Removal

1. Remove the quarter trim panel (31012). For additional information, refer to Section.

2. Remove the nut and bolts and safety belt retractor.

Retractor - Front Seat Safety Belt, Convertible

Installation

NOTE: Make sure the safety belt is not twisted.

1. The shipping clip must remain attached prior to the installation of the retractor into the vehicle.

The clip must be removed after the retractor is installed.

Retractor - Front Seat Safety Belt, Convertible

2. Position the safety belt retractor. Install the nut and bolts.

Retractor - Front Seat Safety Belt, Convertible

3. The shoulder belt must pass through the belt holder on the top of the seatback

Retractor - Front Seat Safety Belt, Convertible

4. Install the quarter trim panel. For additional information, refer to Section.

5. Check the active restraint system for correct operation.

    Retractor - Front Seat Safety Belt, Coupe
    Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal 1. Remove the quarter trim panel (31012). For additional information, refer to Section. 2. Using the special ...

    Retractor - Rear Seat Safety Belt, Coupe
    Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal 1. Remove the quarter trim panel (31012) and the angel wing trim. For additional information, refer to Section ...

    Other materials:

    Removal
    1. Remove the differential housing cover (4033) and drain the rear axle (4001). For additional information, refer to Differential Housing Cover in this section. 2. CAUTION: Reinstall the differential pinion shaft (4211) and the bolt in the differential case ...

    Air Conditioning (A/C) Pressure Relief Valve - 4.6L
    Material Item Specification PAG Refrigerant Compressor Oil (R-134a Systems) F7AZ-19589-DA (Motorcraft YN- 12-C) WSH-M1C231- B Removal and Installation NOTE: Installation of a new suction accumulator is not required when repairing the ...

    Paint Codes
    The first set of paint code letters/numbers listed indicate the vehicle primary body color. The second set of paint code letters/numbers listed (if applicable) indicate a two-tone or accent body color. B7 - Zinc Yellow (clear coat) CX - Dark Shadow Gray ...