Ford Mustang (1999-2004) Service Manual: Retractor - Rear Seat Safety Belt, Coupe

Ford Mustang (1999-2004) Service Manual / Body / Safety Belt System / Retractor - Rear Seat Safety Belt, Coupe

Special Tool(s)

Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A)

Removal

1. Remove the quarter trim panel (31012) and the angel wing trim. For additional information, refer to Section.

2. Using the special tool, remove the D-ring bolt.

Retractor - Rear Seat Safety Belt, Coupe

3. Using the special tool, remove the bolt and the safety belt retractor (611B68).

Retractor - Rear Seat Safety Belt, Coupe

4. Remove the bolt.

Retractor - Rear Seat Safety Belt, Coupe

Installation

NOTE: Make sure the safety belt is not twisted when inserting it in the quarter trim panel.

1. Install the bolt.

Retractor - Rear Seat Safety Belt, Coupe

 

Retractor - Rear Seat Safety Belt, Coupe

2. Using the special tool, install the safety belt retractor and the bolt.

Retractor - Rear Seat Safety Belt, Coupe

3. Using the special tool, install the D-ring bolt.

Retractor - Rear Seat Safety Belt, Coupe

4. Install the quarter trim panel (31012) and the angel wing trim. For additional information, refer to Section.

5. Make sure the shoulder belt passes through the belt holder on the top of the seatback.

Retractor - Rear Seat Safety Belt, Coupe

6. Check the active restraint system for correct operation.

    Retractor - Front Seat Safety Belt, Convertible
    Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal 1. Remove the quarter trim panel (31012). For additional information, refer to Section. 2. Remove the nut and ...

    Retractor - Rear Seat Safety Belt, Convertible
    Special Tool(s) Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A) Removal 1. Remove the rear seat cushion. 2. Remove the luggage compartment front lining board (45444). 3. Release the ...

    Other materials:

    Manual seats
    WARNING: Do not adjust the driver’s seat or seatback while the vehicle is moving. WARNING: Rock the seat backwards and forwards after releasing the lever to make sure that it is fully engaged. Moving the seats backward and forward Recline adjustment WARNIN ...

    Supercharger Belt
    Removal and Installation 1. Remove the supercharger drive belt cover. 2. Rotate the supercharger belt tensioner clockwise and remove the supercharger belt. 3. To install, reverse the removal procedure. ...

    Crankshaft Pulley
    Special Tool(s) Remover, Crankshaft Vibration Damper 303-009 (T58P-6316-D) Installer, Crankshaft Vibration Damper 303-102 (T74P-6316-B) Material Item Specification Silicone Gasket and Sealant F7AZ-19554-EA or eq ...