Ford Mustang (1999-2004) Service Manual: Roller Followers
Special Tool(s)
Compressor, Valve Spring 303-452 (T93P-6565-AR) |
Removal and Installation
1. Remove the LH and RH valve cover. For additional information, refer to Valve Cover LH and Valve Cover RH in this section.
2. Position the piston of the cylinder being repaired at the bottom of the stroke and camshaft lobe at base circle.
3. Using the special tool, compress the intake valve spring and remove the roller follower.
4. Using the special tool, compress the exhaust valve spring and remove the roller follower.
5. Repeat Steps 2, 3 and 4 to remove all the necessary roller followers. Inspect roller finger followers and camshafts. For additional information, refer to Section.
6. To install, reverse the removal procedure.
Hydraulic Lash Adjusters
Removal 1. Remove the roller followers. For additional information, refer to Roller Followers in this section. 2. Remove the 16 hydraulic lash adjusters. 3. Inspect the roller followers. For addit ...Camshaft
Special Tool(s) Holding Tool, Camshaft 303-446 (T93P-6256-AHR) Material Item Specification Super Premium SAE 5W-20 Engine Oil XO-5W20-QSP or equivalent WSS-M2C153- ...Other materials:
Rear Spoiler
Removal and Installation
1. Open the luggage compartment lid.
2. Disconnect the high mounted stoplamp electrical connector.
3. Remove the screws and the nuts.
4. CAUTION: Use care not damge the pin-type retainers and pin-type
retainer seals
during re ...
Crankshaft Main Bearing Journal - Clearance
Special Tool(s)
Plastigage
303-D031 (D81L-6002-B) or
equivalent
NOTE: Crankshaft main bearing journals must be within specifications
before checking journal
clearance.
1. Remove the crankshaft main bearing caps and crankshaft main bearing.
...
Installation
1. Overlay the new rear window glass assembly over the old rear
window glass assembly and
transpose the markings with a grease pencil.
2. Center the V-notch on the new rear window glass assembly to the
center mark on the top of the
number four bow ...